Cuttlebug and Magnetic Mats

Using a magnetic mat in your die cutting machine can be a useful way of making frames and apertures in your cards. Since I'm frequestly asked if they are needed; about the sandwich; and just how to do this .... today's card will show you the method I use.

Making an aperture card
I started by making a 4" x 4" card, which I scored round four sides.

Any make of die will make your aperture.  Tape the die to the inside of the card - cut side down - use a low tack tape to secure.

Place the magnetic mat inside the card

and fold the front card over securing the die on the magnetic mat.  Run through the Bug....

Sandwich:  A plate/card encasing the dies and mat/Shim/2 B plates  (I have to use 2 shims, BUT your machine might need less or more..TRY a test run...NEVER force....BEST to start with a thin sandwich).

and you have your aperture card.

You could achieve this result without a magnetic mat, but without the mat you get an impression on the back inside of the card.

Making a frame using a magetic mat

The mat is really useful for making frames

Place the dies on the magnetic mat - place your paper or card over the dies and run through the Bug.

The sandwich is slightly different than usual

A plate/magnetic mat with dies cut side up/paper/ 2 B plates

 (dependent on your machine possibly a shim on top).

In the picture you will see the frame fixed to the aperture card. 

To finish my card I only had to cut a piece of matching paper and add to the inside of the card.

  I also added a a silver thread and  beads. 

The remaining piece of the cut-out can then  be added  to the inside of the card.

It was my intention to use the cut-out from the aperture also on the inside, but after stamping with care and putting on one side to dry....it disappeared....yet to be found!

As you can see magnetic mats to have their uses.

Another such use is to emboss a frame on the front of your card, you can check this out here.
I have used a very quick and easy way of decorating the aperture - the choice is yours!

I have not added a sentiment - this type of card could be used for any occasion, but I thought with Christmas nearly upon us - it would make a very nice Thank You card, should I received a present!


PS: From a query received from Merry: You can buy magnetic mats from many suppliers, the link on the side bar is my supplier. The mats Liz supplies are her own NOT a Spellbinder product and so are much cheaper. They are very magnetic so that the dies hold firm - some mats are much thinner and are only suitable for storing dies. Also the dies do not cut the mats because the cut side is face up. Hope this makes sense and answers some of the points I omitted. ikki

PPS:  Question from Kim:  Can you use the tan mat instead?  NO.  The tan mat does a completely different job - Embossing.